Power plants and electricity
Electricity generation converts primary energy into electrical energy. A coal plant burns coal to boil water, sends steam through a turbine, and drives a generator. A hydro plant uses falling water to spin a turbine. A nuclear plant uses heat from fission to make steam. A combined-cycle plant burns gas in a gas turbine, then uses hot exhaust to raise steam for a second turbine. Cooling towers reject waste heat so steam can condense and the cycle can repeat.
The grid then moves power from plant to user. Alternating current and direct current behave differently in transmission and use. AC dominates long-distance grids. DC appears in batteries and electronics, and in some high-voltage links. Transformers raise voltage for transmission and lower it for distribution.
Articles in this category explain each plant type and its cooling systems, then the AC/DC distinction, in plain steps for general readers, from fuel input to grid output. They describe equipment and energy flow, and how plants connect to the grid, without assuming prior knowledge.
Latest pages
- Electricity transmission over long distances
Electricity transmission moves bulk power from generation sites to substations using high voltage, transformers, and interconnected lines. Raising voltage reduces current and resistive losses, while overhead and underground routes involve different costs, visibility, and repair trade-offs. Grid operators manage these networks, interconnections, and faults to keep power flowing across regions.
- How do solar panels generate electricity?
Solar panels turn sunlight into electricity mainly through the photovoltaic effect in silicon cells. The cells produce direct current, and an inverter changes it to alternating current for home use. A second method, thermal conversion, uses heat and steam to drive a turbine.
- What is baseload power and how it works
Baseload power is the minimum amount of electricity the grid must supply at any moment. It is usually met by plants that can run steadily for long periods, while faster plants handle short peaks.
- How does a coal fired power plant work?
A coal-fired power plant burns coal to boil water, makes high-pressure steam, spins a turbine, and drives a generator. The steam is cooled and returned to the boiler, while ash and other pollutants are controlled before release.
- Power Plant Cooling Towers: How They Work
Power plant cooling towers remove waste heat from condenser water so steam can be condensed and reused. Wet cooling towers use evaporative cooling, while water losses are replaced with makeup water and controlled with blowdown. Their size and draft method depend on plant capacity and site conditions.
- How does a combined cycle power plant work? Explained
A combined cycle power plant runs a gas turbine and a steam turbine from the same fuel source. The gas turbine makes electricity first, then its hot exhaust heats water in a heat-recovery steam generator, and the resulting steam drives a second turbine. This reuse of waste heat can raise electrical output by up to 50 percent compared with a simple-cycle plant.
- How Does a Hydroelectric Power Plant Work?
A hydroelectric power plant uses the energy of moving or falling water to spin a turbine and turn a generator that produces electricity. Water is usually stored behind a dam, released through a penstock, and returned to the river through a tailrace. Output depends on both water flow and the elevation change, or head.
- Difference Between AC and DC Electricity: How They Work
AC reverses direction periodically, while DC moves charge in one direction. AC dominates power grids and household supply; DC powers batteries, electronics, and many control circuits. Most real systems use both, often converting one to the other.
- How does a nuclear power plant works: from fission to grid
A nuclear power plant is a thermal power station powered by a nuclear reactor. The reactor splits uranium atoms, releases heat, and that heat makes steam that drives a turbine connected to an electric generator.