Headphones and audio
Headphones and audio equipment turn electrical signals into sound. A headphone driver contains a magnet, voice coil, and diaphragm; current in the coil moves the diaphragm and pushes air. Speakers do the same at larger scale. Digital audio stores sound as samples, often 44.1 kHz and 16-bit for CD, then converts it back to analog. Sampling rate sets the highest reproducible frequency, and bit depth sets dynamic range. This category explains those parts and terms.
Articles cover noise-canceling headphones, which use microphones and anti-phase signals to reduce low-frequency noise; frequency response, which shows output level across bass, midrange, and treble; and impedance, measured in ohms, which affects how much power a device needs. It also explains codecs, Bluetooth, amplifiers, and room acoustics. Bluetooth codecs such as SBC, AAC, aptX, and LDAC compress audio with different bit rates and latency. Amplifier output and headphone sensitivity, often measured in dB per milliwatt, determine loudness.
Readers can use these pages to compare specifications, understand measurements, and choose equipment that matches their source device and listening environment. The focus is on mechanisms and measurable behavior, not brand claims.
Latest pages
- Headphones One Side Not Working: How to Fix It
A silent ear can come from a loose plug, dirty jack, unbalanced audio setting, Bluetooth glitch, or damaged wire. Start with the simplest checks, then move to cleaning, pairing, and cable repair. Many cases are fixed without buying new headphones.
- DAC for Headphones: What It Is and Whether You Need One
A DAC converts digital audio into an analog signal that headphones can reproduce. You may need one when your source is noisy, underpowered, or limited in format support; many everyday setups already sound fine without it.
- How to Clean Headphones and Earbuds Safely
How to clean headphones safely means matching the method to the part: dry debris removal first, then a barely damp cloth, then targeted agents such as mild soap, alcohol, peroxide, or vinegar. Keep liquid away from drivers, ports, and seams, and let every part dry fully before use.
- Open back vs closed back headphones: what's the difference?
Open-back headphones let sound pass through the ear cups, while closed-back headphones seal the rear of the cups. Neither design is inherently better; each suits different places, music, and listening habits.
- What Are Planar Magnetic Headphones? Audio Guide
Planar magnetic headphones produce sound using an ultra-thin film layered with conductive circuits and positioned between opposing magnet arrays. Unlike conventional dynamic drivers that push a cone from a central point, planar drivers move the entire diaphragm uniformly. This balanced movement reduces acoustic distortion and delivers rapid transient response across a wide frequency range.
- How Do Noise-Canceling Headphones Work?
Noise-canceling headphones reduce unwanted sound with two layers: physical isolation from the ear cups and padding, and active noise cancellation that uses microphones and processing to create an opposing signal. The result is strongest on steady low-frequency noise and weaker on sudden or high-pitched sounds.
- What is frequency response in headphones?
Frequency response in headphones is the range of audio frequencies a pair can reproduce, from low bass to high treble. It also describes how evenly those frequencies are played back. The best response depends on your ears and listening habits, not one fixed number.
- What Is Headphone Impedance? A Practical Guide
Headphone impedance is the electrical resistance headphones offer to an audio source, expressed in ohms. It affects how much voltage or current is needed for a given volume and whether a phone, laptop, or dedicated amplifier is a good match. Choosing the right value depends on both the headphones and the device driving them.